In the navigation panel, go to Monitoring → Alerts.
The table of alerts with the following columns will be displayed:
Name.
State.
Possible values:
Enabled
Disabled
Inactive
Data source: The data source of the alert trigger.
This column includes additional information:
Type: The type of the metrics used for the alert trigger.
Possible values:
Repositories: System metrics.
Metrics: pgpro-otel-collector metrics.
Logs: pgpro-otel-collector logs.
This type of metrics is temporarily not supported.
Parameters:
Interval, sec.: The interval in seconds for checking the data source of the alert trigger.
Flap check, count: The number of repeated triggers required for stopping the alert.
0 means that this limitation is disabled.
Notify after, sec.: The time in seconds during which the trigger must continually fire for the alert to be sent.
Cooldown period, sec.: The time in seconds during which the alert is not sent after the last trigger.
0 means that this limitation is disabled.
Priority.
Possible values:
Not classified
Low
Medium
High
Critical
Recipients: The users that receive alerts.
Group recipients: The user groups that receive alerts.
Rule: The alert trigger rule conditions.
For example, if an alert trigger rule condition is postgresql.up > 0,
the alert is sent when the value of the postgersql.up
metric exceeds 0.
Actions.
For more information about available actions, refer to the corresponding instructions.